Dynojet 424: Quickstart guide for DWRT User Manual download pdf

1. Insert the Dynojet Power Core CD in your CD-ROM drive. The launch program will run automatically.

If auto-run is disabled on your computer, click Start on the Windows task bar, and click Run.

Type D:\setup.exe, where D corresponds to your CD-ROM drive.

2. Follow the on-screen instructions to install the Power Core software.

3. Double-click the Power Core program icon installed on your desktop or on your start menu. This will

run the Dynojet Application Launcher.

4. Click WinPEP 8 Dyno Control from the Application Launcher.

5. Connect to DynoWare RT Control. See page 2 for more information.

6. Turn on the DynoWare RT main module. Allow several minutes for your computer to

connect to the main module.

INSTALL YOUR SOFTWARE

Quick Start Guide

Dynojet Research 2191 Mendenhall Drive North Las Vegas, NV 89081

1-800-992-4993 www.dynojet.com

DynoWare RT - 224 Dynos

DynoWare RT Main Module

(DWRT)

I.D.

Connect the pendant cable to the DynoWare RT module.

Connect the atmospheric cable to the DynoWare RT module.

Connect the four-pin communication cable from the Air Fuel Ratio module to the

DynoWare RT module.

Connect a primary RPM pick up cable or a secondary pick up cable to the DynoWare RT module.

Connect the six-pin speed/brake cable to position 1 on the DynoWare RT module.

Note: For 4WD dynos, connect the speed/brake cable from the stationary dyno to

position 1 and connect the speed/brake cable from the moveable dyno to position 2.

Connect the ethernet cable from the ethernet port on the DynoWare RT module to your

Local Area Network or directly to the network port on your computer. Refer to your dyno

installation guide for more information.

Connect the three-pin temperature sensor cable to the three-pin port on the Eddy Current Brake

driver module.

Note: Make these connections for both Eddy Current Brake driver modules for 4WD dynos.

Connect the five-pin load cell cable to the five-pin port on the Eddy Current Brake driver module.

Note: Make these connections for both Eddy Current Brake driver modules for 4WD dynos.

Set the ID switch on the Eddy Current Brake driver module to 0 for 2WD dynos.

For 4WD dynos, set the Eddy Current Brake driver module ID switch on the

stationary dyno to 0 and set the ID switch on the moveable dyno to 2.

Connect the four-pin communication cable from the front of the Eddy Current Brake driver

module to the DynoWare RT module.

CABLE ROUTING

DWRT ECB AFR

Eddy Current Brake

Driver Module (ECB)

Air Fuel Ratio Module

(AFR)

98200047.01

1 2

Summary of Contents

Page 1 - Quick Start Guide

1. Insert the Dynojet Power Core CD in your CD-ROM drive. The launch program will run automatically. If auto-run is disabled on your computer, clic

Page 2 - DynoWare RT - 224 Dynos

WINPEP 8 DYNO CONTROLWINPEP 8 DATA CENTERHome and Data RibbonsFor more information on Dynoware RT, visit us online at www.dynojet.comor call 800-992-4

Comments to this Manuals

No comments

Dynojet 424: Quickstart guide for DWRT User Manual

Browse online or download User Manual for Equipment Dynojet 424: Quickstart guide for DWRT. Dynojet 424: Quickstart guide for DWRT User Manual

Summary of Contents

Comments to this Manuals

Related products and manuals for Equipment Dynojet 424: Quickstart guide for DWRT