Dynojet WinPEP 7 User Manual download pdf (Page 150)

WinPEP 7 User Guide

APPENDIX F

Data Link Module - HD Delphi ECM Set Up

F-8

CONFIGURING THE MAKERUN SCREEN

The gauges displayed on the MakeRun screen are completely configurable. Editing a

gauge allows live data from the Data Link Module to be displayed on the MakeRun

screen. Any data from the Data Link Module will always be recorded when you sample

a run. Dynojet recommends displaying live gauges on the MakeRun screen to help

verify data is streaming from the Data Link Module to WinPEP 7.

For more detailed information on gauges, refer to “Creating and Editing Gauges

(Templates)” on page 6-12.

1Click the Edit Mode button . You cannot edit gauges unless you are in Edit

Mode.

The gauge toolbar will appear.

2 Choose the style of gauge you would like.

3 Click and drag, holding the mouse button down as you do so, on the MakeRun

screen until the dotted box is the desired size. Release the mouse and the gauge

will appear.

4 Edit the gauge properties.

Each type of gauge has a slightly different dialog box, but most share the same

properties. Most channels available are standard channels, but the channels that

are listed with an asterisk are from peripheral devices (Expansion Systems).

4a Right click on the gauge and choose Gauge Properties.

The Gauge Property Editor dialog box will appear.

4b Select a Data Channel from the drop down list.

The Prefix *H_ indicates data channels that are available from the Data Link

Module. Other expansion systems have an asterisk (*) in front of the channel

name. Data channels without an asterisk (*) in front of their names are

information from your dyno.

Data Channel determines which channel the gauge is linked to (such as the Data

Link Module). The data channels that you selected when you configured your

Data Link Module are the ones that are available. If you do not see a data channel

that you think should be shown, make sure that you had its check box selected

when you configured your scanner. Some types of gauges automatically place the

name of the Data Channel selected on the gauge. Digital gauges do not display

the name and will require you to add a label.

Note: You must be connected to the dyno electronics for the list of channels to be

available.

1 2 ... 145 146 147 148 149 150 151 152 153 154 155 ... 169 170

No comments

Dynojet WinPEP 7 User Manual Page 150