Dynojet WinPEP 7 User Manual download pdf (Page 73)

ADVANCED MAKERUN FEATURES

Edit Run Information

Version 2 WinPEP 7 User Guide

6-3

Tire Speed Rating—The maximum safe speed for the tire’s rating and condition. Tire

speed is limited by the max design speed (maximum safe speed of the dynamometer).

If you enter a value greater than the max design speed, the tire speed rating will

change to the max design speed. While in Novice Mode, all Speed gauges will

automatically configure to the value entered here. Enter the tire speed rating in mph.

(the units may vary depending on your environment options) as follows:

• non-rated - 93 mph

• S - 112 mph

• H - 130 mph

• V - 150 mph

• Z - 150 mph and higher

Plug Fires Every—This is the number of degrees the crank rotates between RPM

triggers. This value affects the values displayed on the RPM gauge. Make sure your

plug fires value is configured correctly. If your plug fires value is incorrect, the RPM

gauge values will not match the actual RPM of your vehicle.

• Every Other Revolution = 720 degrees

• Every Revolution = 360 degrees

• Twice Every Revolution = 180 degrees

• Four Times Every Revolution = 90 degrees

For example, consider a bike with a four cylinder four-stroke with two coils. It

fires both coils once per revolution (wasted spark on exhaust stroke). Degrees

between plug fires = 360.

If you do not know the number of degrees to enter, just leave it at its default (360

degrees). Compare the vehicle RPM gauge with the RPM gauge on the screen and

verify they match; change your plug fires selection until they match.

Altitude—Enter the current altitude. The altitude is not used by WinPEP 7, but is for

informational purposes only.

Run Type—Choose the type of run you are making. The type does not affect the run

in any way; it is only meant to be another way of keeping notes. You can add one

custom value by typing it in the Type input box shown in Figure 9.

• RO - Roll On

•AG - All Gears

•FA - Fast Acceleration

•NG - Negative

• LC - Load Control

Air Fuel Heater—Turn the Air/Fuel Heater on and off. The heater must be on for the

sensor to function.

Air/Fuel Type—Select from gasoline or methanol alcohol (alcohol) fuel types. This

option is only available if you have purchased the Air/Fuel module.

Real Time Weather—Monitor real time weather values from the dyno electronics.

Relative Humidity, Intake Air Temperature, and Absolute Pressure are measured and

saved. These measurements are used to correct power and torque for atmospheric

conditions according to an SAE, DIN, JIS, EEC, or STD formula.

Run Notes—Enter any notes or information to save with the next run.

1 2 ... 68 69 70 71 72 73 74 75 76 77 78 ... 169 170

Comments to this Manuals

No comments

Dynojet WinPEP 7 User Manual Page 73

Comments to this Manuals

Related products and manuals for Software Dynojet WinPEP 7